Maintenance; Emptying The Collection Tank; Installing & Cleaning Reusable Cloth Filter - Craftsman 125.12001 Manual Del Operador

Maintenance

Emptying the Collection Tank

1
2
1. Verify that the power cord is
disconnected from the outlet. (Fig. 1)
2. Disconnect the hose from the vacuum.
(Fig. 2)
3. Undo the latches and remove the power
head from the collection tank. (Fig. 3)
Place power head on a soft, clean
surface upside down.
4. Clear all dirt or debris from the collection
tank and hose into a proper waste
container. (Fig. 4)
5. Clean or replace the fi lters. (Fig. 5)
See fi lter cleaning instructions on
page 11-12.
6. Check the hose, attachments, and
power cord to verify that they have not
been damaged.
Installing & Cleaning Reusable Cloth Filter
1
Installing Reusable Cloth Filter
1. Verify that the power cord is
disconnected from the outlet. (Fig. 1)
2. Remove power head and place in the
upside down position.
3. Slide reusable cloth fi lter down over the
fi lter cage making sure the whole cage
is covered. (Fig. 2 & 3)
4. Replace and secure the power head on
to the collection tank.
3 3
2 3
4
7. Place power head on collection tank and
secure latches.
NOTICE! The fi lter included is made of
high quality material designed to stop small
dust particles. The fi lter should be used for
dry pick-up only. A dry fi lter is necessary
to pick up dust. If the dust fi lter is wet, it
will clog quickly and be very diffi cult to
clean. Handle the fi lter carefully when
removing it for cleaning and replacing it.
Check the fi lters for tears or small holes, a
small hole can let dust pass through and
out of the cleaner. Do not use a fi lter with
holes or tears, replace it immediately.
4
Removing and Cleaning Cloth Filter
1. With the removed power head in the
upside down position.
2. Carefully remove the reusable cloth fi lter
from the fi lter cage. (Fig. 4) Clean the
fi lter by gently tapping or brushing dirt
off. Cleaning should not be done
indoors in living areas.
3. Use a mild soap and water solution to
wash reusable cloth fi lter and rinse with
clean water. (Fig. 5)
4. Allow the wet fi lter to air dry for 24 hours
before installing onto the fi lter cage.
11
5
5