When to replace the exhaust filter
AirClean
Replace this filter every time you start a
new packet of Miele FilterBags. Every
packet of original Miele FilterBags con-
tains one AirClean exhaust filter. Multi-
packs contain four AirClean filters.
How to replace the AirClean exhaust
filter (Fig. 27)
Do not use more than one exhaust fil-
ter at a time.
Open the dust compartment lid.
Release the filter frame and raise it
upwards. Grasp the used AirClean
filter by the clean, unsoiled section
(see arrow) and take it out.
Replace it with a new AirClean ex-
haust filter.
If you wish to fit an Active AirClean
30 or HEPA AirClean 30 exhaust fil-
ter, see "Replacing one type of ex-
haust filter with another".
Close the filter grille.
Close the dust compartment lid.
When to replace the Active AirClean
30/HEPA AirClean 30 exhaust filter
(Fig. 12)
Replace this filter when the exhaust fil-
ter TimeStrip® change indicator is
completely red.
The indicator lights up after approxi-
mately 50 operating hours, which is
equivalent to about a year of average
use. You can continue vacuuming when
the light comes on. However, the suc-
tion power will be reduced as will the
effectiveness of the filter.
How to replace the Active AirClean
30/HEPA AirClean 30 exhaust filter
(Fig. 28)
Do not use more than one exhaust fil-
ter at a time.
Open the dust compartment lid.
Lift the exhaust filter and remove it.
Insert a new exhaust filter, making
sure it goes in properly, then push it
down into position.
Press the TimeStrip® exhaust filter
change indicator (Fig. 10).
After approx. 10–15 seconds a thin red
line will appear in the left-hand side of
the display (Fig. 11).
If you wish to fit the AirClean exhaust
filter, see "Replacing one type of ex-
haust filter with another".
Close the dust compartment lid.
en-US
19