Xiaomi Mi Vacuum Cleaner G9 Manual De Usuario página 9

Care & Maintenance
Installing the Dust Compartment, Pre-filter, and
Cyclone Assembly
1. Insert the cyclone assembly vertically into the dust
compartment, and make sure that the handle of the cyclone
assembly line up with the slot on the left side of the dust
compartment. Turn the handle clockwise until it locks, then flip
the handle down.
2. Place the pre-filter with its front side facing up into the cyclone
assembly.
2
1 Pre-filter
14
3. Slightly tilt the dust compartment so its slot aligns with the clip
on the vacuum cleaner. Then gently push the dust compartment
until it clicks into place.
1
Insert until
2
it clicks into
place
Cleaning the HEPA Filter
Note: It is recommended to clean the HEPA filter once every 4
to 6 months.
1. Remove the dust compartment as shown in the figure.
2
1
Dust Compartment Release Switch
2. Remove the HEPA filter from the vacuum cleaner by pulling it
down in the direction shown in the figure.
3. Clean the HEPA filter with clean water. Make sure you rotate the
HEPA filter 360° to thoroughly remove all dust caught in the filter.
Lightly tap the filter several times to remove any excess dirt.
Notes:
Only use clean water to clean the filter. Do not use detergent.
Do not attempt to clean the HEPA filter with a brush or finger.
15