Rothenberger Industrial 072990E Instrucciones De Uso página 37

Tabla de contenido

Publicidad

- Pull the cleaning coil (3) out of the plastic
housing (5) and insert it into the pipe until
you reach the blockage (resistance).
To allow the cleaning coil to move
forward, and at the same time preventing
it from bending or getting twisted, use the
locking wheel (4) to secure it so that there
is a distance of 30 cm between the pipe
opening and the cleaning coil's locking
wheel.
- Insert the drill chuck into the hexagonal
adaptor (2) and tighten it.
- Use the handle (6) to ensure a secure grip
and start the drill off clockwise at a low
speed, increase the speed depending on
the level of blockage.
- Once the locking wheel has reached
the pipe opening, loosen it and unwind
more of the cleaning coil so that the
30cm distance between pipe opening
and the locking wheel can be maintained.
Then secure the locking wheel again.
Repeat this process until the blockage is
removed.
- When you have finished, gradually
remove the cleaning coil from the pipe,
clean thoroughly and manually re-insert
into the plastic housing.
Make sure that the drill is disconnected from the hexagonal adaptor when the
cleaning coil is being pulled back into the housing.
MAINTENANCE AND SERVICING
In order to clean it thoroughly, the entire cleaning coil should be removed from the
housing at regular intervals. Do not use any chemical cleaning agents when cleaning the
coil.
RECYCLING
Devices which are no longer usable must be disposed of at a recycling centre
and must not be disposed of in general household waste. For more information
please contact the relevant local authority in your area. Dispose of the packaging
accordingly and in line with the local regulations in your area.
072990E_Anleitung.indb 37
4
3
2
5
5
37
6
31.03.15 13:17

Publicidad

Tabla de contenido
loading

Tabla de contenido