Grounding Instructions; Basic Operation - Hurricane 120 VOLT AM2400D Instrucciones De Funcionamento

ENGLISH

GROUNDING INSTRUCTIONS

General – This air mover shall be grounded while in use to protect the operator from electrical
shock. The machine is provided with a three – conductor cord and a three – contact grounding
type attachment plug to fit the proper grounding type receptacle.
The green (or green & yellow) conductor in the cord is the grounding wire. Never connect this wire to
anything other than the grounding pin of the attachment plug.
Make sure that all the safety functions are normal, and ensure that the actual operation voltage is in
accordance with the required voltage rate.Make sure that the machine is connected to an outlet
having the same configuration as the plug. No adapter should be used with this machine.
This machine is intended for commercial use only. It is constructed for use in an indoor environment
and is not intended for any other use.

BASIC OPERATION

1)Check the machine for any obstructions in fan prior to operation.
• If an item blocks the intakes of the air mover, this will hurt the performance of the machine,
and could cause the motor to overheat.
2)Adjust machine to desired position for operation by pulling it back to its preset height
adjustments.(Air blower drying direction without Transport kit refer to
3)Plug power cord into a grounded outlet.
• Do not use an extension cord in conjunction with the standard power cord.
4)This machine has 3 power settings. Turn the power knob to the desired speed.
• Low = 1 Med = 2 High = 3.
5)To stop the machine at any time, simply turn the power knob to the "off" position.
• Never stick any object into the air inlet vents or the air outlet vent.
DAISY CHAIN
The AM2400D can be connected in a "Daisy Chain" allowing for two aditional
work together on one circuit
NOTE: The Air Mover has an onboard circuit breaker. If the auxiliary outlet overloads, the circuit
breaker will trip. If the breaker trips, unplug the units and press the circuit breaker reset button. Plug
the units back into the power source and turn on the switch.
refer to .
Figure 2
OPERATING INSTRUCTIONS
Figure 1
7
)
units
AM2400D