Ingeteam
10.22. Perform a ventilation test
Occasionally you need to test the proper performance of the unit's fans. These units have the option of performing
a ventilation test.
To perform the ventilation test access Main menu > Settings > Test Fans. Press
fans start to turn. Wait until the display shows that the test has finished. If one or several of the fans do not turn, a
ventilation fault is displayed. If all ventilators turn, the test's result is positive.
The ventilation test only checks the turning of the fans. A positive ventilation test alone does
not indicate that the system's ventilation status is correct. To assure proper performance of the
ventilation system, also check that there are no elements obstructing air passage and that the fans
are properly installed.
10.23. Change display language
To change display language, access the Main menu > Settings > Languages.
10.24. Change date and time
To change the inverter's date and time access Main menu > Settings > Date & time.
10.25. Perform a partial delete of accumulated data
These inverters have total and partial meters for energy produced, connected time to grid and number of
connections to grid made. This data may be viewed in Main menu > Monitoring.
If you wish to delete the partial meters, access Main menu > Settings > Partial delete.
10.26. Block inverter screen
If you want to block the keypad/screen together to avoid undesired changes access Main menu > Advanced settings
> Block display and enable the block. To unblock it, press
Main menu > Advanced settings > Block display and disable block.
Pressing
you access the configured country / regulations information.
40
to start the test. The unit's
in this order for three seconds. Re-access
ABE2013IQM01_A - Installation and Operation Manual
Display control