Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ANTI-TIP BLOCK
NORMAL INSTALLATION STEPS
Anti -Tip BLOCK Installation Instructions
To reduce the risk of tipping of the drawer, the
Anti-Tip block must be properly installed located
14 13/16-inches above the floor on which the
Drawer Microwave will sit. The anti-tip block must
be provided and pre-installed by the purchaser of
the product or builder before install can be done.
The anti-tip block is not provided by installer. See
Figures 1 and 2.
The Anti-Tip block
prevents serious
injury that might
result from spilled
hot liquids.
If the Drawer
Microwave is
ever moved to a
different location,
the Anti-Tip block
must also be moved and installed. When installed
to the wall, make sure that the screws completely
penetrate the dry wall and are secured in wood
or metal so that the block is totally stable. When
fastening, be sure that the screws do not penetrate
electrical wiring or plumbing.
ELECTRIC OUTLET
The electrical requirements are a 120 volt 60 Hz, AC
only, 15 amp. or more protected electrical supply.
It is recommended that a separate circuit serving
only this appliance be provided.
The drawer is equipped with a 3-prong grounding
plug. It must be plugged into a wall receptacle that
is properly installed and grounded. Should you only
have a 2-prong outlet, have a qualified electrician
install a correct wall receptacle.
Note: If you have any questions about the
grounding or electrical instructions, consult a
qualified electrician or service person.
* Can also be installed using an electrical outlet
in an adjacent cabinet within the area where the
provided electrical cord can reach. Always check
electrical codes for requirements.
T
Suggested electrical
outlet location*
Installation Instructions
6"
Anti-Tip
block
3
/
"
1
2
Figure 3
5"
4"
Figure 4
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an
electrical short circuit, grounding reduces the risk
of electric shock by providing an escape wire for
the electric current. This appliance is equipped with
a cord having a grounding wire with a grounding
plug. The plug must be plugged into an outlet
that is properly installed and grounded. Consult a
qualified electrician or serviceman if the grounding
instructions are not completely understood, or if
doubt exists as to whether the appliance is properly
grounded.
WARNING
Improper use of
the grounding plug
can result in a risk of
electric shock.
Do not use an
extension cord. If the
power supply cord
is too short, have a
qualified electrician
or serviceman install
an outlet near the
appliance.
DRAWER INSTALLATION
1. Place the drawer adjacent to the wall or cabinet
opening. Plug the power supply cord into the
electrical outlet.
2. Carefully guide the drawer into the prepared
opening. Avoid pinching the cord between the oven
and the wall.
3. Slide the drawer all the way until the mounting
flange is flush with the face of the cabinet. See
Figure 5.
4. Open the drawer. Using the
4 holes on the drawer as a
template, pre drill the cabinet
using a 1/16" bit. See Figure 5.
5. Secure the drawer with the 4
screws supplied.
4
Permanent and Correct Installation
3-Prong plug
Grounding pin
3-Prong receptacle
Grounded receptacle box
Mounting
Flange
Figure 5
Parts supplied
4 Screws
Publicidad
Tabla de contenido
