Status Indication - Inateck BCST-60 Guia Del Usuario

1. Connect Inateck BCST-60 with computer via USB cable
2. Power on Inateck BCST-60 by toggling switch from OFF to ON and short press
the trigger. Inateck BCST-60 will continuously beep. Beep stops after successful
connection.
3. Open a file on computer and move cursor to the blank where scanning output
should be placed. Scanning results can be displayed on computer then.
Function Setup
(Note: The barcode marked by "*"means default setting of Inateck BCST-60.)
Users must read setup barcodes in order to change the default settings in Inateck
BCST-60 Barcode Scanner.

Status indication

Buzzer Indication
Beeping
One short high note（100ms）
One short high note（20ms）
One long high note（400ms）
One or several long high notes （800ms）
Three chord sounds
Two short notes（tone from low to high）
Two short beeps (tone from high to low)
LED Indication
Indicator color
Green LED flashes once (LED2)
Blue LED flashes once (LED2)
Blue LED stays on (LED2)
Yellow LED blinks（light/shade ratio0.5s :
0.5s） (LED1)
Red LED stays on (LED1)
Meaning
Read barcode successfully
Data upload from scanner to Computer
Wrong Setup （on setup status, blue LED stays on）
Invalid scanning due to full buffer (Scanned barcode not saved.)
Pairing Failure (Occurs only during the pairing process)
USB being configured（It happens when USB cable is inserted）
Enter setup mode（Blue LED on）
Exit setup mode（Blue LED off）
Correct Setup
The connection between Inateck BCST-60 and computer is disrupted.
Meaning
Barcode successfully read and uploaded to computer
Barcode successfully read and saved in buffer, but not uploaded to computer
Inateck BCST-60 scanner on setup status
Low battery
Inateck BCST-60 scanner in charge (Red LED off when battery is full)
Scan"Enter setup"barcode;
Change scanner setting by
scanning certain function
setup barcode;
Scan "Exit with save" barcode
to finish the setup.
3