Excel XLERATOR Serie Manual Del Usaurio

R E A D A N D S AV E T H E S E I N S T R U C T I O N S
1. Unpack all items from the shipping box.
2. Review items against the following list:
1. Hand Dryer
2. Tamper-Proof Wrench
3. Installation and Owner's Manual
3. Report any missing or damaged items.
4. Locate the Dryer Model Number and Serial Number on
the Dryer nameplate and record the date below.
5. Read and save these instructions.
Dryer Model
Serial Number
Date Of Purchase
WARNING: For proper electrical connections,
check your local building codes. Your unit must
be installed by a qualified, licensed electrician.
WARNING: To reduce risk of fire, electric shock
or injury to persons, observe the following:
A Use this unit only in the manner intended by the
manufacturer.
B Before servicing or cleaning unit, switch
power off at service panel and lock the service
disconnecting means to prevent power from
being switched on accidentally. When the service
disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a tag
to the service panel.
GENERAL SAFETY INSTRUCTIONS
• Troubleshooting and internal maintenance must be performed by
qualified service personnel.
• Do not use any power wash equipment for cleaning on or near this unit.
PLEASE SEE OUR WEBSITE, www.exceldryer.com FOR WARRANTY, TROUBLESHOOTING, AND PARTS INFORMATION
E X C E L D R Y E R , I N C
3 5 7 C H E S T N U T S T R E E T, E A S T L O N G M E A D O W , M A 0 1 0 2 8
INSTALLATION AND OWNER'S MANUAL
XLERATOR
MODELS: XL - BW W GR C SB SI SP WITH OR WITHOUT SUFFIX:
RECEIVING SHIPMENT
MODEL INFORMATION
IMPORTANT SAFETY INSTRUCTIONS
1 . 8 0 0 . 2 5 5 . 9 2 3 5 E X C E L D R Y E R . C O M
AND XLERATOReco
®
HAND DRYER MODELS
1 2
110–120V
208–277V
110–120V
208–277V
• Do not use the XLERATOR dryer for drying hair.
• Do not obstruct air inlets or outlets.
PRE INSTALLATION WIRING SAFETY INSTRUCTIONS
• Check that the electrical supply corresponds to that shown on the
rating sticker of unit. Do not connect the dryer to any electrical
supply other than that stated on the rating sticker of the unit.
Permanent damage or improper, unsafe operation of the unit
may result.
• Make sure electricity is switched off at the main panel before
installing, maintaining or cleaning this hand dryer.
• The Dryer must be installed in accordance with current local wiring
and building regulations.
• Do not wire this hand dryer into the lighting circuit. It must be
protected by an independent circuit.
• The Dryer is intended to be permanently connected to the power
supply, and must be properly grounded.
A D M I N @ E X C E L D R Y E R . C O M
EN
®
ECO V H
3
11.3 – 12.2A
5.6 – 6.2A
4.3 – 4.5A XLERATOReco
2 – 2.2A XLERATOReco
1 1 / 2 0 1 7 1