Briteq LD SMART DIM Manual De Instrucciones página 9

ENGLISH
How to select and memorize the "preselected zones":
1. Press the MODE-button + JOG WHEEL together for 5seconds: the buttons of all 6 zones start blinking
Press the zones that you want to indicate as "preselected" zones: these selected zones will stop
2.
blinking and stay on.
3. Press the MODE-button + JOG WHEEL together for 1second to confirm and permanently memorize this
setting.
Remark: if you don't confirm the setting within 10seconds, the controller goes back to normal mode without
memorizing the "preselected" zones.
OPERATING INSTRUCTIONS
The LD-SMART DIM has three different working modes:
1. Static mode
2. Scene mode
3. Sequence mode
Static mode
The user can operate the LD-SMART DIM in static mode by setting the value for the dimmer and color for
any selected zone.
The mode button toggles the different functions, the user is always able to change the dimmer of course. If
the selected zone contains an RGB-projector, the user can control the color by pressing on the mode button
until the "color" LED is on.
Use the jog wheel to change the color of the selected zone (the selected "zone" button takes the same color
as the connected projector).
Multiple zones can be selected at the same time.
You can also press the mode button to select the fade function (fade LED is on): now you can use the jog
wheel to set the desired fade time between different colors.
For example: Select the zone 1, then press the Mode button until the dimmer LED is on, turn the jog wheel
to set the dimmer at 50%, then press again on the mode button, the color LED will be on, turn the jog wheel
to adjust the color. Turn the jog wheel counter clockwise, the color of the LED button is changing on zone 1.
Press on the first zone button to unselect it, then press on the second zone to select it, press on the mode
button until the fade LED is on, turn the jog wheel to adjust the fade time.
Results: the first zone is dimmed at 50% in red color, the zone 2 is fade mode at selected speed.
If you want to save this scene, please read the next paragraph.
Scene mode
You can store up to 6 scenes:
Edit and save a scene:
1. Sequence LED = Off
2. Press MODE button to change the dimmer, color, fade
3. Select one or several zones, then turn the jog wheel to adjust the dimmer level, color, fade speed.
4. Press one of the buttons 1-6 for 3 seconds, the related LED will flash three times, which means the
scene is stored successfully.
5. Repeat steps 2-4, to store up to 6 scenes.
For example: to edit a fade time and save it on button "3".
1. Sequence LED = off
2. Press "mode" button until Scene LED is on
3. Press one of the buttons 1-6 to playback the scene to edit
4. Press MODE button to change the dimmer, color, fade
5. Select one or several zones to edit
6. Turn the jog wheel to fine tune the dimmer, color or the fade time
7. Press the desired scene button "3" for three seconds, the related LED on button 3 flashes three
times, the scene is stored successfully.
BRITEQ
®
7/44
OPERATION MANUAL
LD-SMART DIM