Publicidad
Idiomas disponibles
Idiomas disponibles
Step 3
- Once all the anchors are in place, move the ceiling plate back into position. Attach the W-C washers
(4) and the W-A concrete screw on each hole and tighten. Do not fully tighten until all bolts are in
place.
- Once all bolts are in place tighten with a Phillips screwdriver until fully tight.
W-B
W-C
W-A
Attaching the projector plate
Step 1
- This projector ceiling mount comes with four adjustable legs. All four legs will not be used on
certain projectors.
- Place the projector plate in the center of the projector and locate the projector's mounting points at
each corner of the device.
- Slightly adjust the projector plate's adjustable legs to t into the projector holes.
- Use the corresponding washers and screws to x the projector plate in place.
B
Note: Depending on the brand and model of each projector it will be necessary to make some
adjustments to install the projector plate. Some projectors' mounting points may be di cult to reach
following the standard installation.
Please follow the steps below in case the projector you are trying to mount has this characteristic:
1. Locate the hardest to reach point on your projector (in this case it is placed in the center of the
projector's main base).
2. Remove all the adjustable legs from the projector plate; for this type of installation all the legs will
be individually adjusted.
M- / A M-B/M-C/M-D
M-E/M-F/M-G/M-H
Publicidad
