GE G131 Manual Del Propietário página 6

About washer features.
Tab
2
3
SETTINGS
4
OFF
2nd
Set when adding
RINSE FABRIC SOFTENER
EXT.
SPIN
FABRIC SOFTENER
+ 2nd RINSE
Turning Tabs
3
5
6
Turning Tabs
6
The Fabric Softener Dispenser
The fabric softener dispenser automatically releases liquid fabric softener at the proper time
during the cycle.
Do not stop the washer or raise the lid during the first spin. This will cause the dispenser to
empty
too soon.
Never pour fabric softener directly on clothes. This may cause stains on your clothing.
To use, follow these steps:
Lift the tab on the fabric softener
1
dispenser top.
Measure out fabric softener into
2
the cap and pour the softener into
the dispenser top. The fabric softener
will drain into the receiving cup inside
the dispenser. Use only "Ultra" or
concentrated fabric softeners.
Push down on the tab to close
3
the dispenser top. Make sure the tab
is pushed down fully and snaps shut.
Select FABRIC SOFTENER from SETTINGS
4
on the control panel.
Cleaning the Fabric Softener Dispenser
The Fabric Softener Dispenser is self cleaning. This dispenser does not require regular cleaning
like standard fabric softener dispensers. Wipe down exterior surfaces of the dispenser
as needed. If cleaning of the internal dispenser components is needed, follow these steps
after the wash cycle is complete:
Lift the dispenser top tab and turn the top
1
counterclockwise using the 2 turning tabs
shown. Lift the dispenser out of the
Infusor™.
Clean out any buildup from inside the
2
Infusor™ with a soft cloth or toothbrush.
Ensure the three rectangular holes
in the bottom which allow the fabric
softener to drain are not blocked.
Gently pull the cap away from
3
the dispenser cup to separate.
Wipe surfaces with a soft cloth or soak
4
the parts in a solution of 1 gallon warm
water, 1/4 cup liquid detergent and 1 cup
bleach. Ensure the small hole in the top
surface of the cap and associated tube
are not obstructed.
Reassemble the dispenser cup and cap
5
by snapping them together.
Place the dispenser assembly into
6
the Infusor™. Turn the top clockwise
using the 2 turning tabs shown. Push
down on the tab to close the dispenser
top. Make sure the tab is pushed down
fully and snaps shut.
(on some models)
NOTE: Overfilling the dispenser will cause
fabric softener to drain out of the holes in the
side of the infusor when filling. Do not overfill.
(on some models)