Publicidad
Idiomas disponibles
Idiomas disponibles
Reversing Door
12
Preparing to reverse door swing
1 Be sure you have adequate swing area before reversing door.
2 You will need a screw driver with a #2 square bit.
3 Protect fl at work surface, such as top of washer or fl oor near
washer, with a soft cloth or towel.
4 Be sure washer is unplugged from power source!
Removing door and hardware
A) Removing Trim Ring
1 Open the door to a 90 degree angle.
2 Remove and save the trim plug and long,
course-thread, panhead screw.
3 Close the door.
4 Rotate the door trim approximately ¾"
counter-clockwise and pull it away from the
front of the door.
WARNING
ELECTRICAL SHOCK HAZARD
Failure to disconnect power source before servicing
could result in personal injury or even death.
B) Removing Door from Hinge
1 Reopen door to 90 degree angle.
2 Remove 4 long, course-thread, counter-sunk
hinge screws from door.
3 While supporting the weight of the door
with both hands, separate the door from the
hinge.
4 Gently place the door face down on a fl at,
covered work surface.
Tools needed:
Screwdrivers with
#2 square &
straight bit
Publicidad
