Cleaning Spark Arrestor Screen; Cleaning Fuel Sediment Cup - Honeywell HW3000 Manual Del Propietário

Cleaning Spark Arrestor Screen

Cleaning Spark Arrestor Screen
WARNING
Muffler reaches temperatures that can cause serious
burns if touched. NEVER touch hot surfaces.
Generator muffler is equipped with spark arrestor screen,
which must be cleaned according to maintenance sched-
ule (Table 2).
To clean spark arrestor screen, you will need:
‰ Slotted screwdriver
‰ Pliers
‰ Wire brush
Stop generator if engine is running. Allow to com-
1.
pletely cool.
Place the generator on a flat, level surface.
2.
3. Loosen the spark arrestor clamp screw (A) with a slot-
ted screwdriver.
A
B
FIGURE 43: Spark Arrestor Assembly
Remove spark arrestor clamp.
4.
5. Using pliers remove the spark arrestor screen cover
(B) using a gentle rocking motion.
Remove the spark arrestor screen (C).
6.
Inspect spark arrestor screen.
7.
„ If screen is damaged or excessively worn, replace
with new screen.
„ If screen is in good condition, clean using wire
brush and then reinstall.
FIGURE 44: Clean Screen
8. Reinstall remaining spark arrestor components care-
fully aligning screw holes.
24 www.honeywellgenerators.com
C

Cleaning Fuel Sediment Cup

The sediment cup helps prevent fuel tank residue from
entering the carburetor.
Clean fuel sediment cup at the intervals specified in
Table 2.
To clean fuel sediment cup, you will need:
‰ 10 mm box wrench
‰ 22 mm open end wrench
‰ Household soap and water
‰ Clean, dry cloth
To clean fuel sediment cup:
1. Stop engine if it is running. Allow to completely cool.
Place the generator on a flat, level surface.
2.
3. Turn fuel shut-off valve to OFF position.
While holding the fitting above the fuel shut-off valve
4.
with a 22 mm open end wrench, remove the fuel sedi-
ment cup assembly (sediment cup, o-ring, and fuel
screen) using a 10 mm box wrench.
FIGURE 45: Fuel Sediment Cup Assembly Removal
5. Clean fuel screen (A), o-ring (B), and sediment cup
(C) with soap and water.
FIGURE 46: Fuel Sediment Cup Assembly
Rinse parts thoroughly with water.
6.
7. Wipe pieces clean with clean, dry cloth.
Reinstall sediment cup, o-ring, and fuel screen.
8.
9. Turn fuel shut-off valve to ON position.
Start generator and check for leaks.
10.
HW3000/HW3000L Portable Electrical Generator Owner's Manual
A
B
C