Door removal
Electric Shock Hazard
WARNING
Disconnect electrical supply to refrigerator before
installing. Failure to do so could result in death or
serious injury.
If your access door is too narrow for the
refrigerator to pass through, remove the refrigerator door and pass the
refrigerator laterally.
Remove lower
Remove 2 screws holding the lower cover in place. Pull up the feed water tube while
cover and
pressing area
then feed water
tube
Remove the
1) Removing the hinge cover by loosening
freezer
compartment
door
2) Remove the keeper by rotating it counter
3) Remove the freezer compartment door by lifting
Remove the
1) Loosen the hinge cover screws and
refrigerator
compartment
door
2) Remove keeper by rotating it clockwise
3) Remove the refrigerator compartment
12
shown in the figure to the right.
NOTE
•
If a tube end is deformed or abraded, cut the part away.
the screws. Separate all connection wires
except for the earth line after.
clockwise ( ) and then lifting the upper
hinge up ( ).
NOTE
•
When removing the upper hinge, be careful that
the door does not fall forwards .
it upward. This time, the door should be lifted
enough for the feed water pipe tube to be
completely pulled out.
NOTE
•
Move the freezer compartment door passing through the access door and lay it
down, but be careful not to damage the feed water pipe tube.
remove the cover. Remove connection
wire, if any, except for the earth line.
( ) and then remove the upper hinge
by lifting it up (
).
door by lifting it up.
Installation
Feed water tube
Hinge
cover
Upper hinge
Keeper
Lower hinge
Connection
wires
Upper hinge
Lower hinge
Lower cover
Connection
wires
Ground Line
Upper hinge
Keeper