Cold Laminating Procedure; Color Foil Laminating Procedure; Important - RS HSH-1300 Manual De Instrucciones

COLD LAMINATING PROCEDURE

1. Set the laminator in the COLD lamination mode by pressing the HOT/COLD button.
60°C(140°F)
2. The symbol will appear and you will hear 3 beeps when the machine is in the cold temperature mode. The
machine is now ready for lamination.
3. Place the document to be laminated on the adhesive side of the cold film with the document face down.
4. Insert the document to be laminated into the front opening of the machine.
Remove the paper liner from the cold film slowly while the document is being inserted into the machine.
NOTE: When switching the machine from the hot to cold mode, please wait until the rollers cool down. It will take
approximately 20-30 minutes.
The symbol will appear and you will hear 3 beeps.

COLOR FOIL LAMINATING PROCEDURE

IMPORTANT: Carrier is required for Foil Lamination
1. Set the temperature and speed according to the pouch thickness (FOIL).
Please refer to the SPECIFICATIONS section for recommended settings.
2. The READY (
The machine is now ready for lamination.
3. Position the color foil on the document with the color side facing up. When you are applying the foil to small areas or
using different colors, use the tape that's included to hold the foil in place.
4. Place the document into the paper carrier.
5. Insert the carrier into the front opening of the machine.
6. The carrier will exit out the rear of the machine when completed.
NOTE: Your laminated item will be hot and can easily bend. To keep your laminated item flat, place on a flat surface and
allow to cool.
) symbol will stop blinking and a symbol will appear when the correct temperature is met.
10
set temperature