Samson AirLine ATX Manual Del Usaurio página 9

Charging the ATX Transmitter
1.
With the AR99m powered off, connect the included power adapter.
2. Insert the magnetic power cable to the AR99m USB Port (or any 5-volt DC adapter that
has a USB port).
3.
Turn the VOLUME knob on the AR99m clockwise to turn its power on.
4. Place the ATX transmitter on a flat surface.
5. Attach the magnetic connector to the gold contact power port on the bottom of the ATX
transmitter. The cable attaches to the port magnetically.
The magnetic connector is keyed so it will only connect in one direction.
Note: Transmission is disabled during charging.
6. Look at the indicator light on the ATX transmitter to determine when the transmitter has
finished charging. When the light is flashing red, the ATX is charging. When the red light
stops flashing it indicates that the ATX is fully charged.
7. Disconnect the magnetic power cable from the ATX when the unit is fully charged.
If you notice your ATX battery life is becoming shorter after a full charge, you can order a user
replaceable battery from your local Samson distributor.
Getting the most out of the rechargeable battery:
• Completely charge the batteries before first use
• Fully charge the battery before it will be used.
• After the battery is charged, unplug the charger from the outlet.
• The optimal temperature range for using and storing the battery is 50°F -
86°F (30°C - 50°C). The battery performance and operation may decrease in
temperatures below 50°F (30°C).
A warning that batteries (battery pack or batteries installed) shall not be exposed to excessive
heat such as sunshine, fire or the like.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type. Attention should be drawn to the environmental aspects of battery disposal
AirLine AWXm Wireless System 9