eLine REALPOWER Instrucciones De Uso página 29

EN
• If the lever (HH) starts pressing the quick
release in the advanced work position (fig.16),
screw the left bushing pin (FF) (fig. 17) so that the
lever starts working inside the predefined work
area (between 30° and 45°).
• If the lever (HH) starts pressing the quick
release in the delayed work position (fig.18),
unscrew the left bushing pin (FF) (fig.19) so that
the lever starts working inside the predefined
work area (between 30° and 45°).
28
• After establishing the correct position of the left
bushing pin (FF), hold the left bushing pin with
one hand (FF) and with the other, tighten the ring
(EE) (fig. 20) thus clamping everything.
16
• Close the lever (HH) in the "close" position,
pushing it only with the palm of the hand (fig. 21
and 22) and taking care not to put fingers between
the lever and frame (fig. 23).
17
18
19
20
21
22
23