Power On And Off; Wearing The Unit; Important - ClearSounds QUATTRO Manual Del Usaurio

POWER ON AND OFF

█
To turn the QUATTRO ON:
Press and hold the Multi-Function Button on the side of the
QUATTRO for 3 seconds. A series of 4 tones (low to high) can
be heard from your hearing aid/cochlear processor when it is in
t-coil mode or from the headset if connected. The LED flashes
blue 4 times.
To turn the QUATTRO OFF:
Press and hold the Multi-Function Button on the side of the
QUATTRO for 3 seconds. A series of 4 tones (high to low) can
be heard from your hearing aid/cochlear processor when it is in
t-coil mode or from the headset if connected. The LED flashes
red 4 times before switching off.

WEARING THE UNIT

█
1. Place the loop around your neck and insert the round
connector plug into the Neckloop Quick Disconnect
plug, forming a continuous loop.
IMPORTANT: To have the Neckloop operate properly, you will
need to be sure the Quick Disconnect connection jack has been
securely clicked in place. There will be two distinct clicks.
2. Make sure your QUATTRO is paired to the device you
wish to use.
3. The QUATTRO allows non hearing aid/cochlear implant
wearers or hearing aid/cochlear implant wearers without
t-coils to connect a 3.5mm headset or ear bud (SmartSound
Earbuds with Reverse Sound technology by ClearSounds are
recommended). Connect your 3.5mm headset or ear buds
directly into the charging jack located on the bottom of your
QUATTRO (see Location of Controls diagram).
4. For hearing aid/cochlear implant wearers with t-coils,
switch your device to "T."
10 – ENGLISH