Introduction; General Rules; Ambient Conditions; Meaning Of The Symbols - INE SKYLINE60 Manual De Instrucciones

INE SpA Via Facca, 10 - 35013 Cittadella - PADOVA - ITALIA Tel. 049/9481111 - Fax 049/9400249 - ine@ine.it - www.ine.it
1

Introduction

SKYLINE 60/90/120 is an innovative current generator
for the plasma cutting of metals, designed for even
the most discerning professional, while being extremely
simple to use for the less experienced operator to
guarantee results that are always perfect. It is designed
for use in light-to-heavy structural steel works.
These power sources have been designed and
implemented on the base of the most updated and
innovative technologies conceived for inverters and
microprocessors in power electronics and signal
processing. Thus a system has been achieved that, in
addition to the traditional dependability of INE products,
is featuring high dynamics of the necessary control for
obtaining very good quality cutting.
The generator gives excellent quality cuts without
burring on the reverse for both fine and medium thick
sheets in soft steel, stainless steel, aluminium and
aluminium alloys.
The pilot arc is initiated by starting LIFT (without the use
of high frequency); this allows excellent outward
absence of electromagnetic interference. An automatic
restart device allows the continuous cutting of punched
plates and grids.
The protection systems on the generator make it
extremely safe to use and protect its integrity in case of
overheating and overloads.
Furthermore, with the innovative intake power control
function it is ideal for using with any any sort of power
of mains exploiting all its available energy.
Furthermore, these main characteristics are supported
by the traditional sturdy and reliable construction of INE
machines.
SKYLINE 60/90/120 cutting machines are constructed
according to the following standards EN 60974:
•
as far as operators health prevention against electric
shocks is concerned.
•
as far as electromagnetic compatibility is concerned
(noise disturbing other
operating in the vicinity).
INE declines any liability should the cutting machine be
used incorrectly (ex.: to defrost pipes, to charge
batteries, etc.) or modified by the customer or third
parties without any
manufacturer.
INE generators have been designed for professional
use and must be used exclusively by adequately
trained persons.
electrical appliances
written approval by
2

General rules

It is possible to work without risks only after
having fully read and understood the
operating and safety instructions, and of
course by complying with these strictly.
The safety rules/laws of the country where the
equipment is installed are to be observed.
It is protected electronically against overloads. Don't
use fuses having a higher amperage than the one
specified in table "TECHNICAL DATA".
3

Ambient conditions

The system can withstand the following ambient air
temperature ranges:
When cutting:
-10°C to +40°C (+14°F to +104°F)
During transport and storage:
-25°C to +55°C (-13°F to +131°F)
Humidity is not to exceed:
50% at +40°C (104°F)
90% at +20°C (68°F)
Welding, transport and storage are to be done within
such ranges. Trespassing them is to be regarded as a
violation. The producer will not be responsible for
damages caused by this.
The environmental air must be free of conductive dust,
corrosive gases, acids and other substances that may
damage the system.
4

Meaning of the symbols

Death or serious injury hazard!
Failure to comply with the safety precautions
can
consequences and even death.
the
Damage hazard!
Failure to comply with the instructions and/or
the safety precautions can cause damages
to the system and to the pieces being
machined.
Detach the power supply plug!
Disconnect the power supply plug before
operating inside the system.
Page 10
On the machine.
DANGER! Please read
instructions contained
manual.
cause accidents or
the
in the
severe