Tips For Installation - Elkron DT16 Manual De Instrucciones

With swivel bracket (ref. 80SP5D00113)
The swivel bracket will be applied in a horizontal
manner or directly to the wall with screws and
dowels or on the support through the bracket
screws. It allows orientation of + / - 45 ° vertically
and +30 ° in the opposite direction to that of the
guidance arrows in the horizontal plane. Drill the
locations B and C on the plastic bottom. Drill the
"Cable Entry 2" which will also serve to regulate the
swivel bracket. Pass the cable through the swivel
bracket and "Cable Entry 2". Place the plastic
bottom on the swivel bracket with the bracket
screws. Orient the swivel bracket and tighten the
locking screw through the "Cable Entry 2". Screw
the circuit board to the plastic bottom.
Proceed with the cable connection.
Cable connection
Connect the cable to the terminal as in the scheme. Adjust the range
through the trimmer (see chapter "Setting").
If it is necessary, perform the setting of operating. Apply the Plastic Front.
Run the walk test by checking the detections through the LEDs. Tighten
the closing screw.
Apply the Filter LED. This element has a dual function:
•
allows you to leave ON the LEDs so that they can not be seen at a
distance by an intruder, but allowing the verification of operation only in
the immediate vicinity of the sensor by the user;
•
hide aesthetically the closing screw of the detector.

TIPS FOR INSTALLATION

In indoor installations, prefer placement of the sensor toward the inside of
the room and away from operating machinery and heat sources.
Avoid to direct it toward the windows exposed to the sunny. In outdoor
installations, prevent that the sun's rays, especially during the hottest
hours of the day, come directly to the infrared sensing element.
Note: pay attention to not darken, even partially, the detection view
For protection of walls, avoid that a sensitive area of infrared is in contact
with the wall, in order to don't cancel the benefit of the dual-element
infrared sensor.
Overcome this by mounting the sensor detached from the wall (see table),
Table of distance A function of the
range selected
8 m
4 m
2 m
or orienting the sensor of a few degrees (<10 °) using the optional swivel
bracket accessory
6
Distance A
70 cm
35 cm
18 cm
DT16
YES
YES