Operation; Adjusting The Display Contrast - Elkron FKP500 Manual De Instalación

In normal operation conditions, the same information appears on the display as on control panel; on the first line of
the display, there is shown information typical of FKP500 Consolle such as the address and control character of
call from control panel.
When data communication between control panel and remote panel is interrupted, following massage appears on
the display and the buzzer is activated. To locally silence the buzzer, press key ACQUIRE.
When control panel is being programmed, following information will be shown on remote panel display.

4.1 ADJUSTING THE DISPLAY CONTRAST

The display contrast can be adjusted as follows:
•
With the panel turned on, press the TEST LAMP and < keys at the same time.
•
The contrast adjustment bar and ambient temperature will appear on the display.
• To increase the contrast, press the TEST LAMP and ∧ keys at the same time.
• To decrease the contrast, press the TEST LAMP and ∨ keys at the same time.
•
To exit the adjustment menu, press the TEST LAMP and > keys at the same time.
The contrast adjustment value is lost when the panel is turned off.

OPERATION

4
Panel address
Consolle ID 10
FIRE PREVENTION SYSTEM
19/06/08
Master Control Panel
Consolle ID 10
*** ANOMALIA *** MANCANZA COMUNICAZIONE
**** FAULT ***** COMMUNICATION FAILURE
**** FALHA ***** AUSENCIA COMUNICACAO
Consolle ID 10
REMOTE PROGRAMMING ENABLED
15/40
11:50
FKP500