Addressing; Technical Specification - Elkron FKP500 Manual De Instalación

On the left side of the board of FKP500 Consolle there are present 5 jumpers allowing to set panel address.
Place the jumpers based on desired address; this operation must be performed with panel powered off.
Supply voltage: ...........................................................17 ÷ 30Vdc
Typical current consumption:......................................70mA @25Vdc
Maximum current consumption: .................................200mA @25Vdc
Serial bus:...................................................................RS485 with 2 wires, opto-isolated, 9600 Bit/s
Relay:..........................................................................1A @ 30Vdc, resistive load
Operating temperature:...............................................-5 ÷ 50 °C
Relative humidity: .......................................................95% Ur. Max.
Housing protection degree:.........................................IP43
Dimensions (LxHxD) :.................................................290 (11.42) x195 (7.67) x 50 (1.97) mm (inch)

6 ADDRESSING

1 2
5 6
9 10
13 14
17 18
21 22
25 26
29 30
Fig. 7 – Selection of the address via the jumpers

7 TECHNICAL SPECIFICATION

21/40
3 4
7 8
11 12
15 16
19 20
23 24
27 28
31 32
FKP500