Tools Needed; Hardware Provided - Koala Kare KB110-SSWM Instrucciones De Uso

KB110-SSWM
Please Note: To assure proper installation, it is suggested that a qualified person or carpenter install the Koala
Baby Changing Station. Koala Kare Products will not be responsible if the station is not installed properly. Koala Baby
Changing Stations have been tested to hold a substantial static load. The unit must be attached to a permanent wall
that is capable of holding a substantial load. The maximum recommended total weight for this baby changing station
(including baby and parcel bag) is 60 lbs. Excessive weight may cause a hazardous or unstable condition to exist.
Restraint System: To fasten the waist restraint strap, place strap around child's midsection, and push spring tabs into
buckle until both spring tabs lock in place with an audible "click". Straps can be adjusted to make strap tighter or looser
as required.
Inspection Criteria:
A properly maintained baby changing station should be inspected on a daily basis and parts replaced if they do not
pass inspection criteria.
• Has a pneumatic shock that controls the smooth opening and closing of the unit. Shock may need replacement if
door opens or closes too rapidly or door doesn't close completely.
• Has both ends of a functioning, non-frayed strap: buckle clicks when closed and strap is attached to unit at both
ends.
• Has a warning label affixed to the product.
• Offers parents liners through a fully stocked liner dispenser. (Dispenser built into unit.)
• Provides a clean changing surface for customers to attend to their children.
Replacement Parts
For a list of replacement parts for this product, (such as straps, shocks and labels) please visit koalabear.com.
Replacement parts and additional liners can be purchased from your local distributor or direct from Koala at
koalabear.com.
gloves
1/8" (3 mm)
(regular masonry)
&
drill bits
Operating Instructions

Tools Needed

drill pencil
Phillips head
screwdriver

Hardware Provided

four ¼"x 3" (6 mm x 76 mm)
Phillips panhead wood screws
measuring
stud finder
tape
7/32" (6 mm)
(regular masonry)
&
drill bits
level
½" (13 mm)
(regular masonry)
&
drill bits
four ¼" (6 mm)
flat washers