Lcd Display; Care And Maintenance - HoMedics SC-505 Manual De Instrucciones

2. Your weight will be shown on the LCD display as shown below.
3. The scale turns off by itself after use.
NOTE: Place the Analyzer/Scale on a firm, flat surface to achieve best accuracy.
TROUBLE SHOOTING
1. You must have bare feet when using body fat and total body water measurements.
To get the most accurate and consistent reading, wipe your feet with a damp cloth,
leaving them slightly moist before stepping on scale.
2. Be sure your feet are centered on the electrodes.
3. Display Err0 Initialization error. The user is advised to take the measurement again
for an accurate result.
4. Display Err1 Wrong usage or body not stable. Repeat measurement again.
5. Display Err2 Overload Warning. Remove the weight immediately; otherwise,
permanent damage to the scale will occur.
6. Display Err3 Contact error. Impedance cannot be measured. Make sure that you are
standing still on the scale and maintain maximum contact between
your feet and metal contacts. Clean bottom of feet with a damp cloth,
leave slightly moist, and repeat measurement again.
7. Display Err4 Body fat percentage is beyond the technical limit. Clean bottom of feet
with a damp cloth, leave slightly moist, and repeat measurement again.
8. Display Err5 Percentage total body water is out of range. Moistening your feet may
help to improve the contact.
9. Display L L o o Replace the battery when "Lo" is displayed.
10. The condition of the skin on the bottom of your feet can affect the reading. The natural
effects of aging or activity can make this skin hard. Take the reading with clean, slightly
moist feet for best accuracy.

Care and Maintenance

1. Do not disassemble the scale other than replacing the battery; it contains no user
serviceable parts. Damage to the scale may occur as a result of improper handling.
2. Remove battery when the scale is not used for a prolonged period of time.
3. Clean the scale after use with a lightly dampened cloth. Do not use solvents or immerse
the unit in water.
4. Avoid excessive impact or vibration to the scale, such as dropping it onto the floor.
WEIGHT (WT)
LB
7
The product is intended for home/consumer use only; it is not intended for professional
use in hospitals or medical facilities.
If you are having any problems operating this Body Fat Analyzer, please call
Note:
800-466-3342, between the hours of 8:30 a.m. to 5:00 p.m. EST
Specifications
• Uses BIA (Bioelectrical Impedance Analysis) to determine body fat and total body water percentage
• High precision STRAIN GAUGE technology to determine weight
• Weight Capacity: 330 Lb, 150 Kg or 23 St
• Weight Graduation: 0.2 lb, 100 g, 1/4 lb (Dashes shown below weight reading in Stone mode)
• Body Fat Graduation: 1.0% (in the range from 4% - 50%)
• Body water graduation: 1.0%
• Height Range: 3'3.4" - 7' 2 " (100.0 - 220 cm)
• Age Range: 10 - 99 years
• Measures weight, body fat and total body water simultaneously in about 10 seconds
• Athlete or Normal mode selection
• Weight-only feature
• Auto on/auto off function for convenience and conserving power
• Data can be stored for up to 4 individuals
• User selectable units of measure (Lb/in), (Kg/cm), or (St/in)
• Low-battery indicator
• Operates on one 9-Volt alkaline battery (not included)

LCD Display

Male Icon
'
Memory Mode
M
Ready Mode R
NORMAL
ATHLETE
LOW NORMAL
Female Icon
"
HEIGHT (HT)
CM AGE
KG WEIGHT (WT)
LB % FAT
%
% WATER
MODERATE HIGH
Body Fat and
Body Water Status Bar
MODE
8