Filtrete 3US-AS01 Instrucciones De Instalación Y Funcionamiento página 5

ATTACH WATER INPUT
SUPPLY HOSE:
You will need: 1 length of 3/8" blue tubing (C).
1. Insert one end of one of the lengths of 3/8"
blue tubing (C) into the push-in fi tting side
of the male water supply line adapter (D)
you just installed. Push the tubing in fi rmly
as far as it will go to assure a watertight fi t.
(Fig. 9.1) Warning: Water may leak if the
tube is not pushed in completely. (See
"push-in fi ttings" explanation on Pg. 3.)
2. Take the other end of the same 3/8" blue
tubing (C) and insert into the right (output)
side of the mounting bracket (B). Arrows
on the bracket will be pointing away
from or out of the bracket. (Fig. 9.2)
ASSEMBLE COMPRESSION
KIT/ATTACH WATER
OUTPUT SUPPLY HOSE:
You will need: adjustable wrench,
compression hex nut (E), 3/8" ferrule (G),
3/8" tube insert (F), 1 length of 3/8"
blue tubing (C).
1. Assemble the compression kit. (Fig. 10)
Place the compression hex nut (E) (thread
side facing down) and the 3/8" ferrule (G)
(tapered end down) onto the second length
of blue tubing (C). Insert 3/8" tube insert (F)
into the end of the blue tubing (C).
2. Tighten with a wrench to fi rmly attach
compression kit to the 3/8" cold water supply
shutoff valve. (Fig. 11) Pull on blue tubing to
assure a tight fi t is achieved.
3. Push the other end of the same blue tubing
(C) into the left (input) side of the bracket
(B). Arrows on the bracket will be pointing
towards or into the bracket. (Fig. 12)
(E)
(G)
(F)
(Fig. 10)
5
(Fig. 9.1)
(Fig. 9.2)
C09093B-A5
Filtrete a 3M Brand
3US-PS01
C09093B-A5
Filtrete a 3M Brand
3US-PS01
(Fig. 11)
(Fig. 12)
C09093B-A5
Filtrete a 3M Brand
3US-PS01