Slime SMART REPAIR Instrucciones De Instalación página 2

CAUTION: HOT • DO NOT HOLD IN HAND WHILE OPERATING • PLACE INFLATOR ON A
HARD, CLEAN SURFACE.
1. DO NOT run vehicle while inflator is operating. You may need to be in "accessory"
or "on" position. Please make sure emergency brake is set and car is in park.
Always ensure air hose chuck touches the core of the valve stem for proper
inflation.
2. DO NOT use inflator continuously for more than 10 minutes. Allow unit to cool
approximately 25
minutes between uses. Do not leave inflator unattended.
3. ALWAYS use a pressure gauge to check tyre pressure. DO NOT overinflate.
4. Soft inflatables (i.e. rafts, balls, etc.) may not have recommended pressure
markings. Be careful not to inflate items beyond their capacity.
5. While operating, never block the inflator input or output.
6. Keep inflator out of reach of children.
7. For use with 12 volt DC power outlets rated 15 amps or higher. Do not use with
older 8 amp cigarette lighter receptacles.
WARNING!
This repair kit is only suitable for emergency tyre repairs to enable vehicles to
be driven to a service center where proper repairs can be made to the tyre. Not
intended for use for major tyre damage. Radial ply passenger car tyres may only
be repaired in the tread area. No repairs are permitted on the bead, sidewall, or
shoulder area of the tyre. To prevent injury extreme caution should be used while
using tools. Eye protection should be worn while repairing tyre.
SEALANT REMOVAL INSTRUCTIONS
Slime Tyre Sealant is non-flammable and water based so clean up is simple. The sealant
should be rinsed or wiped out of the tyre prior to making a permanent repair. Should any
sealant fall on the shop floor, simply wipe it up with a rag and rinse off the area with
water. If TPMS sensor present, wipe sensor with damp rag prior to reinstallation. This
sealant will not corrode or negatively affect the rim or tyre.
(FOR THE TYRE REPAIR PROFESSIONAL)