INSTALLATION INSTRUCTIONS
Repairing a flat tyre with a Smart Repair Kit is simple and takes only 15 minutes.
1
5
1. Start by rotating tyre so that the valve stem is in the upper half of the tyre.
2. Slowly remove the valve core with valve core tool provided. Take care to keep a hold of
the valve core as remaining pressure in the tyre can cause the core to shoot out.
3. Allow the tyre to fully deflate.
4. Remove the puncturing object if possible.
5. Place white cap on sealant bottle. Attach filler tube to the bottle tip and tyre valve stem
and squeeze in recommended amount of Slime Tyre Sealant.
6. Replace the valve core.
7. Inflate the tyre.
STEP 1
Place connector on
air valve stem and
push down.
*NOTE: Correct tyre pressure can be found in vehicle owner's manual or on
driver's side door jamb.
8. Drive for .2 mi (.32km) and stop to verify that the puncture has been sealed.
Check tyre pressure. Reinflate if necessary.
2
6
STEP 2
Close thumb
latch connector to
secure to valve.
3
7
STEP 3
Plug power cord into power
outlet receptacle
4
0.2 MI/0.32 KM
PSI
BAR/KPA
8
STEP 4
Turn on inflator and
when proper pressure is
reached, turn off inflator,
unplug power cord and
remove connector.