Arc Welding Hazards - Smarter tools MIG-125 Manual De Instrucciones

1.2 Arc Welding
The symbols shown bel
and identify possible hazards. When you see the symbol, w
the related instructions to a
only a summary of the more complete safety information found in the Safety
Standards listed in Section 1-4. Read and follow all Safety Standards.
Electric Shock can kill.
•
Do not touch
•
Wear dry, ho
•
Insulate yourself from work and ground using dry insulating mats or covers
big enough to revent any physical contact with the work or ground.
•
Do not use AC
danger of falli
•
Use AC outpu
•
If AC output is required; use remote output control if present on unit.
•
Disconnect in
equipment. Lo
1910.147 (see
•
Properly instal
and national, state, and local codes.
•
Always verify the supply ground – check and be sure that input power cord
ground wire is properly connected to ground terminal in disconnect box or
that cord plug is connected to a properly grounded receptacle outlet.
•
When making input connections attach proper grounding conduct
double-check connections.
•
Frequently inspect input power cord for damage or bare wiring – replace
cord immediately if damaged – bare wiring can kill.
•
Turn off all equip
•
Do not use worn, damaged, undersized, or poorly spliced cables.
Hazards
ow are used throughout this man al to call attention to
void the hazard. The safety info
Touching live electrical parts can cause fatal sh
burns. The electrode and work circuit is electrically live
whenever the output is on. The input power circuit an
machine internal circuits are also live when power is on. In
semiautomatic or automatic wire welding, the wire, wire reel,
drive roll housing, and
a re electrically live. Incorrectly installed or improperly grounded
equipment is a ha
live electrical parts.
le-free insulating gloves and body protection.
p
output in damp a
ng.
t ONLY if required for the welding process.
pu t power or stop engine before installing or servicing this
ckout/tago ut input power according to OSHA 29 CFR
andards).
Safety St
l and ground this equipment ac
ment when not in use.
all metal parts touching the welding wire
zard.
reas, if movement is confined, or if there is a
cording to its Owner's Manual
1‐2
u
atch out, and follow
rmation given below is
ocks or severe
d
or first –