Operating Instructions; Control Panel Instructions - Danby Premiere DDR30B1GP Guía De Uso Y De Mantenimiento Del Propietario

CONTROL PANEL
INSTRUCTIONS
Reset filter
button
Continuous
mode
Continuous
mode indicator
CONTROLS
When you push the button to change operation modes, the unit will make a beeping sound to indicate that it is
changing modes.
1) CONTINUE BUTTON
Press to activate the continuous dehumidifying operation.
Refer to page 7.
2) FILTER BUTTON
This product has a check fi lter feature that is a reminder to
clean the air fi lter for more effi cient operation. The check
fi lter light will illuminate after 250 hours of operation. To
reset this function after cleaning the fi lter, press the reset
fi lter button and the light will go off.
3) FAN BUTTON
Controls the fan speed. Press to select either High (Turbo)
or Normal fan speed. Set the fan control to High for
maximum moisture removal. When the humidity has
been reduced and quiet operation is preferred, set the
fan control back to Normal.
4) POWER BUTTON
Press to turn the dehumidifi er on or off.

OPERATING INSTRUCTIONS

NOTE: The control panel of the unit you purchased may be slightly different
depending on the model number.
Check filter
light
Timer button
Auto on
indicator
light
Display
Bucket full
Auto off
indicator light
Up and
down
buttons
5, 7) ( + / - ) BUTTONS
The humidity level can be set within a range of
35% RH (Relative Humidity) to 85% RH in 5% increments
using these buttons.
• For drier air, press the (-) button and set to a lower
percentage value (%)
• For damper air, press the (+) button and set a higher
percentage value (%)
6) TIMER BUTTON
Press to initiate the auto-start and auto-stop feature. Set a
start or stop time from 0.0 to 24 hours using the (+) and (-)
keys. Refer to page 6.
8) DISPLAY
Shows the actual (± 5% accuracy) room humidity level
in a range of 30% RH to 90% RH. Otherwise, displays
selection when programming humidity or timer.
5
Turbo fan speed
indicator
Fan button
Normal fan speed
indicator
Power button
Auto defrost