Where To Set Up Your Device; Installing/Removing The Belt Clip To/From The Parents' Unit; Power Supply; Baby Unit Battery Installation - Silvercrest BABYTALKER 1030 Manual De Usuario

11.2 Where to set up your device

WARNING
Danger due to incorrect use!
Incorrect use of the device, or using it for purposes for which it was not designed, can lead
to danger.
The device must be set up in a location that meets the following requirements:
- In order to minimise the effect of radiation, the baby unit should be set up at least 1 m from the
baby's bed.
- Make sure the power adapter and adapter cable are always out of reach of the baby,
i.e. at least one metre away.
- Never place the baby unit inside the baby's bed or playpen!
- Never cover the baby monitor (e.g. with a towel, blanket, etc.).
- Power sockets must be easily accessible so that the mains cable can be easily removed
if necessary.
- The device must be set up in a dry place.
11.3 Installing/removing the belt clip
to/from the parents' unit
- To remove the belt clip
upwards, while pulling the belt clip tab away from the
unit (A).
- When re-installing the belt clip
locked into position.

11.4 Power supply

• To reduce power consumption, disconnect the device from the power supply and
remove the batteries when the device is not in use.

11.4.1 Baby unit battery installation

• The baby unit can be operated using three AAA batteries/rechargeable
batteries or via the power supply provided.
• The baby unit has no charger.
WARNING
• Remove the batteries if the device is to remain unused for an extended period.
• Never use empty and new batteries together.
56
from the unit, push the belt clip (B)
11
, a click indicates that it
11
Babytalker 1030
A
B