General Description; Feasible Functions - Bio Bronpi PE-130 Instrucciones De Instalacion Y Uso

1 INTRODUCTION
1.1

GENERAL DESCRIPTION

The present document describes the external control or remote central unit and gives the indications of use and connection to the stove.
Read carefully this manual before proceeding to the installation and use of the central unit.
In the box you will receive the next components:
- Remote switchboard
- Green connector to the electronic card.
IMPORTANT: The wire to connect the remote central unit to the electronic card is not included.
1.2 IDENTIFY THE REMOTE CENTRAL UNIT
DISPLAY
1.3

FEASIBLE FUNCTIONS

By using the remote central unit you will be able to make the following remote functions, without the necessity of being in front of the stove or
boiler:
- Turn on/off the stove
- Change the different temperature sets
- Change the heat output
- Access the USER MENU functions and make the desirables changes
- It is not possible to use the remote central unit as a THERMOSTAT OR
CHRONOTHERMOSTAT
It is important to consider that it is not possible to delete the alarms with this
central unit, so in this case it is necessary to be in front of the stove or boiler to
check the causes of the abnormal function of the equipment. It is not possible to
access to the TECHNICAL MENU and modify data of the equipment.
2 CONNEXION FROM THE UNIT TO THE ELECTRONIC CARD
The unit must be connected to the electronic card of the stove/boiler with two
cables, which must be installed in the green connector provided. This plug must
be installed in the connector CN21 of the electronic card and it is necessary to
disassemble the boiler/stove chambers. In the same way you will disassemble
the protector rear cover of the remote central unit.
The connection of the wires must be connected in a specific way so it is
important to pay attention at the moment of the installation. Please, check the
following pictures with the two installation options.
INSTALLATION AND OPERATING INSTRUCTIONS
BUTTON 5
ENTER
Venerdi 00:42
Temp. aria 16.5ºc
Temp. caldaia 21.0ºc
Temp. H20 87ºc
Press. H20 0.6b
Set potenza 3
Set aria 20ºc
Set H20 65ºc
Spento
BUTTON 1
BUTTON 2
ESC
ENTER
BUTTON 4
8
BUTTON 6
ESC
BUTTON 3
REMOTE CENTRAL UNIT PE-130