Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
D. Notes on Recharge
• Avoid charging the watch at high temperatures (about 60°C / 140°F or higher) since allowing
the watch to reach a high temperature during charging can cause deformation or discoloration
of external components as well as a malfunction of movement components.
Examples:
• Charging by placing the watch too close to a light source that may become hot such as an
incandescent lamp or halogen lamp.
• Charging by placing the watch on an automobile dashboard that can easily reach a high
temperature.
• When charging the watch with an incandescent lamp, halogen lamp or other light source that
may reach a high temperature, always make sure to place the watch at least 50 cm (20 in.)
away from the light source to prevent the watch from reaching a high temperature.
E. Replacing the Secondary Battery
This watch uses the secondary battery, which does not have to be periodically replaced
due to repeated charging and discharging, unlike ordinary batteries.
Caution
Never use a battery other than the secondary battery used in this watch.
The watch structure is so designed that a different kind of battery other than the specified cannot
be used to operate it. In case a different kind of battery such as a silver battery is used by some
chance, there is a danger that the watch will be overcharged to burst, causing damage to the
watch and even to the human body.
§5. PRECAUTIONS FOR DISASSEMBLY AND ASSEMBLY
A. How to Pull Out Setting Stem from One-piece Case
1. When removing the setting stem from the case
• Pressing down the end of the unlocking lever for setting stem from above, pull out the setting
stem.
Unlocking lever for setting stem
Crown at the normal position
<Procedure>
(1) Set the crown at the normal position (Push it
in).
(2) Lightly press the end of the unlocking lever
for setting stem with a screwdriver, etc. from
above.
(3) With the lever pressed, pull out the setting
stem.
6
Publicidad
Tabla de contenido
