peerless-AV SUA765PU Instalación Y Ensamblaje página 7

For Flat Back Display
Begin with the shortest length screw, hand thread through washer, tilt bracket and spacer (where required for
2-1
ventilation) into display as shown below. If screw cannot make three full turns into the display and fi t snug into
place, select a longer length screw from the baffl ed fastener pack. Repeat for remaining mounting holes, level
brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of display.
NOTE: If display manufacturer's requirements state that more than 1.2" of ventilation is required, spacers may be
used to add an additional 0.75" of space between the wall and the display as shown below.
DISPLAY
If you have any questions, please call Peerless customer care at 1-800-865-2112.
For Bump-out or Recessed Back Display
Begin with the shortest length screw, hand thread through washer, tilt bracket and spacer in that order into display
2-2
as shown below. If screw cannot make three full turns into the display and fi t snug into place, select a longer
length screw from the baffl ed fastener pack. Repeat for remaining mounting holes, level brackets and tighten
screws.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
WASHER
SCREW
ADAPTER BRACKET (B)
DISPLAY
SPACER
DISPLAY
SPACER
WASHER
ADAPTER BRACKET (B)
7 of 29
ISSUED: 05-01-11 SHEET #: 095-9358-7 11-21-14
WASHER
ADAPTER BRACKET (B)
SCREW
SCREW