Control Panel - THERMEx CITRIN Manual De Instrucciones

CONTROLPANEL
On/off halogen light and dimmer functioning
Button for timer. If this functioning is chosen the ventilator automatically stops after 15 min.
The diode is alight when the timer is on. The following light-emitting diodes indicate periods
of time for the interval induction.
Turn off ventilator
Turn on engine and speed control of the ventilator (the light-emitting diode
shows the chosen speed)
On/off turbo functioning (the light-emitting diode shows when the functioning is chosen)
Light-emitting diode for cleaning of fat filter. After an interval (about 30 hours) the light-
emitting diode indicates that the fat filter should be cleaned. Re-setting of light-emitting
diode: press down the button for about 15 sec. until the diode is off.
Extra functionings:
Controlling of habitation ventilation:
Via the control panel the user has the possibility of programming interval induction. One can choose be-
tween 0, 5, 10 or 15 minutes' ventilation with an hour's interval. First time is started an hour after activation.
Interval induction for room ventilation is always at lowest speed.
Programming of interval induction:
First stop the ventilation on the off-button. Press down the timer button. After about 2 seconds a beep is
heard, then let go of the button and the timer diode is on.
Push down the turbo button to change the time. Speed diode 1 alight = 5 minutes. Speed diode 2 alight =
10 minutes. Speed diode 3 alight = 15 minutes.
If none of the three diodes are alight the function is disconnected. End by pushing the off-button.
The speed diode for the chosen time is blinking, indicating that the interval induction is on.
NB The canopy can always be used normally even though the interval induction is on.