Intellinet 508209 Manual De Instrucciones página 2

English
Connections
SC Fiber / SFP Module
508216 (requires an SFP+ transceiver module that offers fiber
optic connections)
1. Insert the transceiver into the media converter and install the fiber optic
cable into the transceiver.
2. Install the other end of the fiber optic cable into an appropriate port in your
fiber network.
508209 (features a pre-installed SC connector that is not removable)
1. Connect the fiber optic cable to the pre-installed SC connector.
2. Install the other end of the fiber optic cable into an appropriate port in your
fiber network.
Maximum length and fiber cable specification depend on the model.
RJ45
Connect the UTP port of the media converter to powered RJ45 device; e.g., to a
network camera. Cat5e or better cabling is recommended.
Power
Plug the power adapter into the input jack on the media converter. Then connect
it to a regular power outlet. Only use the included power adapter or one with
matching specifications.
Setup
10G
Gigabit
Base-R
Fiber
Fiber
Network
Network
Features
The DIP switches on the Intellinet Gigabit PoE+ Media Converter present helpful
options for extended PoE capability (see next section) and for easily detecting
link faults when they occur (below).
Enabling Link Fault Pass-through (LFP) by switching the LFP DIP switch to "ON"
forces the devices on a link to acknowledge that they are online before data can
be transmitted. When one of the devices doesn't respond, data cannot be sent.
2
10 GB SFP+ (20 km)
Gigabit PoE+ Media Converter
47 V – 57 V
TX RX
10G RJ45 (100 m)