Switching Off - tomado TEB1501W Instrucciones De Uso

Use
Evenly spread the electric underblanket over your mattress, starting at the foot end. Approximately, the cord should be at
shoulder height. The electric underblanket can be used on both sides. Then, as usual, lay the fitted sheet over the bed, so that
the electric underblanket is between the mattress and the fitted sheet. Each time you make the bed, check that the electric
underblanket is flat and properly spread, before you switch it on.
CAUTION!
Make sure the electric underblanket is spread out fully flat and does not fold or crumple during use. We recommend
switching on the electric underblanket about 30 minutes before you go to sleep and covering it with a duvet to prevent
the heat from escaping.
• To operate the electric underblanket connect the control to the underblanket by plugging in the connector.
• Then plug in the supply plug into the mains outlet.
Switching on
Slide the ON/OFF and heating positions slider to heating position 1, 2 or 3 to switch on the electric underblanket.
The temperature settings are illuminated when switched on.
Setting the heating position
Position 0: OFF
Position 1: minimum heating
Position 2: medium heating
Position 3: maximum heating
NOTE
• The feet zone of this electric underblanket is provided with extra heating.
• The quickest way to heat up the electric underblanket is to select the highest temperature setting of the control,
first.
CAUTION!
If the electric underblanket is used continuously (for several
hours) it is recommended to use the lowest setting (1) of the
control to avoid overheating of the user.

Switching off

Slide the ON/OFF and heating positions slider to the OFF position (0) to switch off the electric underblanket. The heating
positions no longer light up.
NOTE
If the electric underblanket is not used for several days, set the slider for ON/OFF and temperature settings to the OFF
(0) position and remove the mains plug from the socket. Then remove the control from the electric underblanket by
disconnecting it at the connector.
EN - 19