Modification Of Manufacturer's Default Program - Astralpool VRAC Manual De Instalación Y Mantenimiento

3.3 MODIFICATION OF MANUFACTURER'S DEFAULT PROGRAM

METHOD: in order to modify a variable, the "ON" key must be pressed to switch the equipment
on, by pointing the control at the valve until communication is obtained, from this point in time
programming may be carried out without being in communication with the valve.
Use the menu keys
Then press "OK" in order to access the language modification screen:
The "+" confirms the function. Press "-" if not required.
Use the
use the
stop times can be modified) the steps are as follows:
First, press "OK" and the following screen will be displayed:
Use the "+" to confirm the function which will display the following screen:
The first digit will flash.
The arrow keys
The "+" will increase the digit.
The "-" will increase the digit.
If On:00:00 and Of: 00:00 are programmed, then the valve will not operate.
Finally press AUTO to confirm the command (ALWAYS POINTING THE PROGRAM-
MING CONTROL AT THE VALVE MODULE AND AT A DISTANCE OF NO MORE THAN
3 m (9.8 ft), OTHERWISE THE FOLLOWING MESSAGE IS DISPLAYED.
(forward) ( back) until the language screen is displayed.
Selected language:
ENGLISH
Do you wish to change
the language?
Press
ENGLISH
to select the language and once selected press "OK" to confirm, then
to access the "FILTRATION 1" screen (the filtration program start and
Do you wish to modify
program 1?
Press: "
On: 00:00
should be placed over the digits to be modified.
THERE IS NO COMMUNICATION
y/n
+ - OK
y/n
+ - OK"
off:00:00
12
ENGLISH