Preparing Dishwasher - LG ADFD544 Serie Manual Del Propietário

us_main.book.book Page 12 Tuesday, September 1, 2020 5:54 PM
12 INSTALLATION
CAUTION
• Water supply pressure must be between 20 psi
and 80 psi (140–550 kPa). If the water supply
pressure exceeds 80 psi, a pressure reducing
valve must be installed. Otherwise premature
failure of the inlet valve may occur.
Connecting Water Supply Line and
Power
Water supply tube: Minimum 3/8" O.D. copper
tubing or metal braided dishwasher supply line
1
Connect the elbow
a
back of the dishwasher.
2
Connect the water supply tube to the elbow.
3
Tighten both connections using two
adjustable wrenches to avoid putting stress
on the water inlet valve.
4
Make sure the water supply is turned off.
Connect the water supply tube to the tap.
5
Insert the power plug into an outlet.
to the inlet valve on the
6
Turn on the water and check for leaks at the
connections.
• If there is a leak, reconnect the elbow.
• Do not cross thread or overtighten the
connections to avoid leakage.
7
Unplug the power cord.
8
Turn off the water supply and disconnect the
water supply tube at the tap.

Preparing Dishwasher

WARNING
• Do not remove safety cover. Removal can result
in fire, electric shock or death.
Releasing Drain Hose
Remove the twist tie holding the drain hose to the
back of the shipping brace.