Component Configuration; Windows 2000/Xp Network - Dynex DX-E201 Guia Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Dynex5x7-multi.book Page 15 Thursday, September 8, 2005 11:07 AM

Component configuration

Component configuration

Windows 2000/XP network

component configuration
Although this procedure contains instructions for Windows 2000, Windows XP
instructions are very similar. For Windows XP, see your Windows documentation.
After the driver has been installed, you must make some changes to your
network settings:
1 Click Start, Settings, Control Panel, then click Network and Dial-Up
Connections. The Network Connections window opens.
2 Double-click the Local Area Connection icon. The Local Area Connection
Status dialog box opens.
3 Click Properties, then check the components listed in the dialog box to
make sure that you have all of the following components installed:
• Client for Microsoft Networks
• Dynex DX-E201 CardBus PC Card
• NetBEUI
• Internet Protocol (TCP/IP)
4 If any components are missing, click Add to install them. Highlight the
component you need, click Add, then double-click the component that you
need to install. Click Close to exit.
15

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido