Installing The Comfoconnect Splitter 5X 0-10V; Connecting Co Sensors; Connecting To The Ventilation Unit; Maintenance - Zehnder ComfoConnect Splitter 5x 0-10V Manual De Instalación

6.3 Installing the ComfoConnect
Splitter 5x 0-10V
Attach the ComfoConnect Splitter
5x 0-10V to the wall with four plugs
and screws. Use plugs and screws
that are suitable for the wall.
Plugs and screws are not
included.
Always tighten the screws by
hand. Do not use power tools.
6.4 Connecting CO
The CO Sensor 0-10V manual
2
describes the installation of the
CO Sensors.
2
Set up the CO
sensor or a regulator. Make
sure that the settings of all
CO Sensors connected to the
2
ComfoConnect Splitter 5x 0-10V
are the same.
Sensors
2
Sensor as a
2
6.5 Connecting to the ventilation
unit
Connect the 0-10V output of the
ComfoConnect Splitter 5x 0-10V
to the 0-10V input of the ventilation
unit.
The ventilation unit manual
describes how to connect to the
ventilation unit.

7. Maintenance

Remove dust from the device with
a dry duster or carefully with a
vacuum cleaner.
Never clean the device with
water.
Never use cleaning agents.
17 EN