Tabla de contenido
Publicidad
1.
Measure and Cut the Bottom Track
Measure here.
Mesurer ici.
Mida aquí.
Curved Base
Base courbée
Base curva
CAUTION: Risk of personal injury. Always wear safety glasses when cutting
materials.
IMPORTANT! If your shower has a curve in the corners where they meet the
sidewalls, be sure to measure from wall to wall above the curves. Failure to measure
above the curve or angle could result in the bottom track being cut too short.
IMPORTANT! Model 660B/SP includes two sets of wall jambs, tapered and standard.
If you are installing the tapered wall jamb, follow the appropriate instructions.
Measure from wall to wall at the flattest part of the shower ledge (dimension "D").
Mark dimension "D" on the bottom track.
IMPORTANT! For best results, use a 32-teeth per inch hacksaw blade and a miter
box to cut the bottom track.
Wall Jambs
Subtract 1/8" (3 mm) from dimension "D" and cut the bottom track to this
dimension.
Tapered Wall Jambs (660B/SP Only)
If you are using the tapered wall jambs, measure from wall-to-wall at the base of
the opening.
Subtract 1-1/16" (2.7 cm) from dimension "D" and cut the bottom track to this
dimension.
All Installations
File the rough edges smooth where the bottom track was cut taking care not to
mar the finished surface.
NOTE: If there are curves where the sidewalls meet the threshold, use a file to
contour the bottom track edges to match the curves.
1113654-2-B
Measure distance "D"
above curves in
the corners.
Mesurer la distance "D"
au-dessus des courbes
des angles.
Mida la distancia "D"
por encima de las curvas
en las esquinas.
D
6
Measure here.
Mesurer ici.
Mida aquí.
Angled Base
Base inclinée
Base en ángulo
Sterling
Publicidad
Tabla de contenido
