FAAC TMK 28 R Manual De Usuario página 16

2
2.1 BOX WITH WALL-FITTED BRACKETS OR CRAMPS
LT Length (Width between the wall-fitted brackets)
Belt (A)
NOTE: THE "LT" LENGTH MUST ALWAYS BE MEASURED BETWEEN THE TWO AXIS-TO-AXIS DISTANCES OF THE HOLES OF THE
WALLED-IN BRACKETS
1. Fully lower the roller shutter.
2. Separate the belt (fig.3 ref.A) from the pulley (fig.3 ref.C ) and release the belts (fig.3 ref.B) from the existing roller.
3. Remove the pulley support from the cramp (fig.4 ref.D)
4. Withdraw the roller from the box.
2.2 BOX WITH SCREWED ON SUPPORTS
LT Length (Width between the screwed on supports)
Support to
be screwed (D)
Belt (A)
NOTE: THE "LT" LENGTH MUST BE MEASURED BETWEEN THE TWO AXIS-TO-AXIS DISTANCES OF THE SUPPORTS TO BE SCREWED
1. Fully lower the roller shutter.
2. Separate the belt (fig.5 ref.A) from the pulley (fig.5 ref.C ) and release the belts (fig.5 ref.B) from the existing roller.
3. Lift the roller, releasing it from the support to be screwed (fig.6 ref.D).
4. Withdraw the roller from the box
REPLACEMENT OF EXISTING WINDING ROLLER
Pulley (C)
Belts (B)
Pulley (C)
Belts (B)
Brackets for
walling-in
Fig.3
Fig. 5
4
Fig.5
Pulley support (D)
Fig.4
Support to be screwed (D)
Fig. 6