Connections, Adjustments And Control Unit Warnings - Teleco TVPLA868AC2 Manual Del Usaurio

1

Connections, adjustments and control unit warnings

P1
Aerial 17
16
P2
15
RAIN
14
Not
sensor
13
used
WIND
12
19
TEMP. Sensor
11
sensor 18
L2
22
LED CARD power
supply (12-24Vdc) 23
M2
Connection of
Earth wires (GND).
LED COLOUR STATUS
L1 RED ON
Temp.
L2 RED One flash every 10 s
Two quick flashes every 10 s
Three quick flashes every 10 s
Four quick flashes every 10 s
Six quick flashes
Seven quick flashes
Eight quick flashes
230Vac
One flash every 2 s
One flash every 3 s
L3 BLUE ON
One flash every second
One flash every 2 s
M1
= Weather sensor alarms (from LOW to HIGH priority)
M2
L1
DIP switch
Memory
L3
Optional LED CARD
(only in TVPLA868AC2 version)
M1 M2 GND
MEANING
Power ON
Water draining alarm (par. 4.4, page 12)
Rain alarm (par. 4.4, page 12)
Ice / Snow alarm (par. 4.2 - 4.3, pages 11-12)
Wind alarm (par. 4.1, page 11)
Built-in motor limit switch activated
Unexpected absorption of one motor in synchronized mode
Safety limit switch
Rain sensor is deactivated
Temperature sensor is deactivated
Synchronized mode activated
Synchronized mode activated (during configuration)
Independent mode activated (during configuration)
= MOTOR alarms
2
1
5 8
M1
4 7
3 6
5A Fuse
Attention! The 230Vac input
of the electronic board and the
motors output are protected by
a 5A fuse.
230Vac
3
1 230 Vac (LIVE)
230Vac
2 230 Vac (Neutral)
Power supply
3 MOTOR 1 (CLOSE)
L
4 MOTOR 1 COMMON
N
5 MOTOR 1 (OPEN)
6 MOTOR 2 (OPEN)
M2
7 MOTOR 2 COMMON
8 MOTOR 2 (CLOSE)
11 WIND SENSOR (BROWN)
12 WIND SENSOR (BLUE)
13 RAIN SENSOR (WHITE, +12Vdc)
14 RAIN SENSOR (BLUE, SIGNAL)
15 RAIN SENSOR (YELLOW, GND)
16 AERIAL RF
17 AERIAL GND
18 TEMPERATURE SENSOR (BLACK)
19 TEMPERATURE SENSOR (WHITE)
22 LED CARD POWER SUPPLY(GND)
23 LED CARD POWER SUPPLY (12-24Vdc)
DIP MEANING
1 - 2 - 3 Setting of wind sensor threshold (see par. 4.1, page 11)
4 - 5 Motor control mode (see pages 4...7)
M1
M2
= It takes effect DURING configuration
FIRST POWER ON: at first power-on, the system is waiting to
be programmed with the memorization of at least one transmitter
(par. 3, page 8) and the configuration of the motors and relative
working time (see below).
MOTOR CONFIGURATION: Identify the correct product
application from the 3 given below and follow the relative
configuration procedure. Attention: if the wrong application is
selected, the configuration procedure must be repeated for the
correct application.