Publicidad
1
Press the c key before the step you want to correct.
*
2
*
The CRT (CORRECT) indicator is on the display while Calculation Memory
editing is enabled.
3
Note that you can only edit values and command key operations (+, -, *,
*
/). You can edit only one step.
4
After you are finished making the changes you want, press the c key again.
*
5
*
Scroll to the last step to check the new result.
6
*
The result is always produced by the calculation. You cannot change it by
inputting a value.
• You can make as many changes as you want, as long as you press
c once to start the editing operation and then once again to end
the editing operation. Do not forget to press c to exit editing after
making the changes you want.
• When you edit the contents of a calculation, the rounding and decimal
place settings in effect when you make the changes affects all steps
stored in Calculation Memory.
• If an error occurs while you are inputting a calculation or editing a
calculation, all the steps are cleared from Calculation Memory and
cannot be reviewed.
• Calculation speed depends on the number of steps accumulated in
Calculation Memory.
1
Presione la tecla c antes del paso que desea corregir.
*
2
*
El indicador CRT (corregir) se encuentra sobre la presentación mientras la
edición de memoria de cálculo se encuentra habilitada.
3
*
Tenga en cuenta que solamente puede editar valores y operaciones de tecla
de mando (+, -, *, /). Sólo se podrá editar un paso.
002
c
002
3
*
5c
003
P
004
P
004
c
004
3c
005
P
006
5
P
*
=
— 56 —
CRT
'
10.
REV
'
5.
REV
(
5.
)
REV
2.
CRT
)
2.
REV
)
3.
=
REV
5.
REV
6
*
6.
Publicidad
Capítulos
