Publicidad
In order to take full advantage of your new product and enjoy long and trouble-free performance, please read this owner's manual
carefully, and keep it in a safe place for future reference.
1) Unpacking: On unpacking your product please check carefully for any signs of damage that may have occurred whilst in transit
from the Laney factory to your dealer. In the unlikely event that there has been damage, please re-pack your unit in its original carton
and consult your dealer. We strongly advise you to keep your original transit carton, since in the unlikely event that your unit should
develop a fault, you will be able to return it to you dealer for rectification securely packed.
2) Amplifier Connection: In order to avoid damage, it is advisable to establish and follow a pattern for turning on and off your
system. With all system parts connected, turn on source equipment, tape decks, cd players, mixers, effects processors etc, BEFORE
turning on your amplifier. Many products have large transient surges at turn on and off which can cause damage to your speakers.
By turning on your bass amplifier LAST and making sure its level control is set to a minimum, any transients from other equipment
should not reach your loud speakers. Wait till all system parts have stabilised, usually a couple of seconds. Similarly when turning off
your system always turn down the level controls on your bass amplifier and then turn off its power before turning off other equipment
3) Cables: Never use shielded or microphone cable for any speaker connections as this will not be substantial enough to handle the
amplifier load and could cause damage to your complete system.
4) Servicing: The user should not attempt to service these products. Refer all servicing to qualified service personnel.
FCC COMPLIANCY STATEMENT
This device complies with Part 15 of the FCC rules Operation is subject to the following two conditions:
1)
2)
Warning: Changes or modification to the equipment not approved by Laney can void the user's authority to use the
equipment.
Note: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
and correct the interference by one or more of the following measures.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
--------------------------------------------------------------------------------
This product conforms to the requirements of the following European Regulations, Directives & Rules:
CE Mark (93/68/EEC), Low Voltage (2014/35/EU), EMC (2014/30/EU),
RoHS (2011/65/EU), ErP (2009/125/EU).
---------------------------------------------------------------------------------
In order to reduce environmental damage, at the end of its useful life, this product must not be disposed of along with
normal household waste to landfill sites. It must be taken to an approved recycling centre according to the
recommendations of the WEEE (Waste Electrical and Electronic Equipment) directive applicable in your country.
---------------------------------------------------------------------------------
This device may not cause harmful interference
This device must accept any interference received, that may cause undesired operation.
EN
Publicidad
