Publicidad
Idiomas disponibles
Idiomas disponibles
PREPARING
THE UNIT
FOR STORAGE
Water should not remain in the unit for long periods of
time. Sediments or minerals can deposit on pump parts and
"freeze" pump action. If you do not plan to use the pressure
washer for more than 30 days,follow this procedure:
I.
Flush detergent siphoning tube by placing filter into pail
of clean water while running pressure washer in low
pressure mode. Flush for one to two minutes.
2.
Shut off engine and let it cool, then remove high
pressure and garden hoses.Disconnect spark plug wire
from spark plug.
.
4.
5.
Empty pump of liquidsby pulling engine recoil handle
about 6 times.This should remove most liquidin pump.
Use pump saver to prevent corrosion build up and
freezing of pump.
Store unit in a clean,dry area.
Protecting
the Pump
To protect the pump from damagecaused by mineral
deposits or freezing, use PumpSaverto treat pump.This
prevents freeze damageand lubricatespistons and seals.
NOTE: PumpSaver is availableas an optional accessory. It
is not includedwith the pressure washer.Contact the
nearest authorized service center to purchase PumpSaver.
CAUTION
• Failure to do so will permanently
damage your pump and
render your unit inoperable.
• Freezedamageis not coveredunder warranty.
CAUTION
Alwayswear eyeprotection when usingPumpSaver.
To use PumpSaver, m ake sure the pressure washer is
turned off and disconnected from supply water. Read and
follow all instructionsand warnings given on the PumpSaver
container.
NOTE: PumpSaverwill drip from pump after treatment
and will stain wood and concrete.
NOTE: If PumpSaveris not available,draw RV antifreeze
(non-alcohol) into the pump by pouring the solution into a
3-foot section of garden hose connected to inlet adapter
and pulling recoil handle twice.
STORING
THE
ENGINE
See the engine owner's manual for instructions on how to
properly prepare the engine for storage.
m
Publicidad
