Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
HOW
TO USE PRESSURE
WASHER
If you have any problems operating your pressure washer,
please call the pressure washer helpline at 1-888-611-6708.
To Start
Pressure
Washer
To start your pressure washer for the first time, follow
these instructions step-by-step.This starting information
also applies if you have let the pressure washer sit idle for
at least a day.
I.
Placepressure washer near an outside water source
capable of supplying water at a flow rate greater than
4.2 gallons per minute and no less than 20 PSIat
pressure washer end of garden hose.
2.
Check that high pressure hose is connected to spray
gun and pump. See"PreparingPressureWasher for
Use" for illustrations.
3.
Make sure unit is in a level position.
4.
Connect garden hose to water inlet on pressure
washer pump. Turn ON the water.
CAUTION
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
5.
Squeeze trigger on gun until you have a steady stream
of water.This
purges the pump of air and impurities.
6.
Attach nozzle extension to spray gun (Figure 6).
Tighten by hand.
7.
Choose the spray tip you want to use and insert it into
the nozzle extension. See "How to Use SprayTips".
8.
Engage safetylatch to spraygun trigger (Figure7).
Safety Latch
9.
Start engine according to instructionsgiven in engine
owner's manual.
• Squeeze trigger on spraygun eachtime recoil starter is
pulledand enginefailsto start.
How to Stop Pressure
Washer
• Turn engine off according to instructionsgiven in engine
owner's manual.
• Squeeze
trigger
on the spray gun to relieve
pressure
in the hose.
NOTE:
A smalt amount of water witl squirt out when you
release the pressure.
Publicidad
