Install Lock
1
Install latch.
Make sure latch angle faces door jamb.
Angle
Actual Size
2
Press levers onto lever posts.
Tip points
down
3
Remove battery cover from the interior thumbturn
assembly.
Unscrew the cover and lift down and out to remove.
Jamb
OR
Wood Block
(Not Included)
4
Install the touchscreen on the outside of door.
Bar should slide smoothly through hole in latch. If not, check door
dimensions.
Angle
5
Install the interior lever assembly.
5a
Route wire through indicated hole below.
5b
Secure interior assembly with screws.
6
Connect wire and battery.
IMPORTANT!
Route wire over the latch.