Conceptronic C54BRS4 Guia De Inicio Rapido página 20

ENGLISH
2. Installation
2.1 Preparing your computer to setup your Conceptronic Broadband router
Please setup your network as shown in the setup diagram below
Connect the UTP network cable from your
computer to the Conceptronic C54BRS4
Before you can configure your broadband router
to use with for instance your Internet provider
you have to connect the power supply to the
wall-outlet and insert the power plug into the
broadband router. After a few seconds the LEDS
of the broadband router will turn green.
Before you can configure your broadband router
through the web browser interface you have to
setup your network computer into the same
network IP subnet range as the broadband
router.
The Conceptronic C54BRS4 works with:
IP address: 192.168.2.1 and subnet mask
255.255.255.0
Conceptronic delivers the broadband router with
DHCP server enabled. This means that every
computer will get an IP address in the range of
the broadband router when the computer is connected to the LAN port of the broadband router.
You can skip this section of the manual when your computers are used as DHCP clients already.